1. CoolAutomation English
  2. Integration Solutions
  3. CoolMaster
  4. How To

CoolMaster - How to set up BMS Connections (Enable BACnet and Modbus)

Yoram
Last update:

This article applies to the following CoolMaster products:

  • CoolMaster
  • CoolMasterPro 
  • CoolMasterNet

1. Enable Modbus IP or Modbus RTU

  1. From the Main screen, tap the Gear icon. The following screen is displayed.
    mceclip0.png
  2. Select BMS Settings by tapping the > button. The following screen is displayed.
    mceclip1.png
  3. Enable ModBus IP and/or ModBus RTU on L3
    mceclip2.png
  4. Reset the device

 

2. Enable BACnet IP or BACnet MSTP 

From the same BMS Settings Screen, you will see additional BACnet options (only available for 2022 CoolMaster and CoolMasterPRO devices, running Firmware Version v0.9.6 or newer)

mceclip0.png

To enable BACnet IP and/or BACnet MS/TP on a legacy COOLMASTERNET, contact CoolAutomation support.
Was this article helpful?
0 out of 0 found this helpful

Articles in this section

See more

Related articles