CoolMaster - Configuration settings

This article applies to the following CoolMaster products:

  • CoolMaster
  • CoolMasterPro 
  • CoolMasterNet

To change the CoolMaster settings, tap the Gear icon on the upper left-hand side of the Main screen. The screen on the right is displayed.

Select Configuration by tapping the > button.

mceclip0.png

The following screen is displayed

mceclip1.png

In this screen you can:

  • Select the desired Temperature scale (°C/°F). This applies only to the way the temperature is displayed on the screen. It does not affect the temperature scale on the HVAC system.
  • Enable the Virtual Com port to allow connection via mini-USB terminal. Required for local configuration with terminal software tools. Used mainly for support.
  • Permit Remote Access (enabled by default). Used when the CoolMaster owner wants remote support.
  • Select About Device by tapping the > button. The following screen is displayed. The screen shows if BACnet IP and ModBus IP are enabled/disabled.

mceclip3.png

 

To enable BACnet IP please contact CoolAutomation support

Was this article helpful?
0 out of 0 found this helpful